Jump to content

BT-SV

From Wikipedia, the free encyclopedia
BT-SV / BT-SW-2
BT-SV
TypeLight cavalry tank
Place of origin Soviet Union
Production history
DesignerTsyganov Group
Designed1937–1938
Specifications (BT-SV)
Mass25 tons
Length562 cm
Width280 cm
Height217.5 cm
Crew4

Armour16–25 mm
Main
armament
45 mm 20KL tank gun
Secondary
armament
7.62 mm DT MG
EngineModel M-17T
500 hp
Power/weight20 hp/tonne
SuspensionChristie suspension
Operational
range
120 km
Maximum speed 52 km/h (32.3 mph)

The BT-SV ( Bystrohodny Tank-Stalin Voroshilov) was an experimental Soviet light tank. In 1936, Soviet engineer Nikolay Tsyganov proposed a new high-speed light tank based on the BT-7. The design was to incorporate sloped armor similar to the T-34, which was also being developed at the time, and a transmission identical to that of the BT-7. The armor was angled at around 15°–58°. It could protect the tank from 45mm rounds. Only two prototypes were built, both of which saw field testing. The vehicle never saw mass production, and resources were instead focused on the production of the T-34 medium tank. All work on this project was abandoned when Tsyganov was arrested during purges in 1938.

Description

[edit]

The main difference of the BT-SV from the BT-7 was the design of the armored hull, the sheets of which were located at large angles of inclination (15° to 58°). The bow had the same width as the entire body. Thanks to this, the front pipe and brackets of the BT-7 tank were unnecessary. The suspension of the front road wheels were similar to the others, but with a spring tilted back at a 38° angle. The body of the BT-SV had no protruding parts at all, with the exception of the caps of the vertical suspension springs. All upper, lower and corner plates of the hull were removable and fastened with bolts. To give the armored closure of the chassis more rigidity, special jumpers (three on each side) were provided between the lower edge of the sheet and the inner wall of the hull. Fuel tanks were located in the sides of the tank. The BT-7 stern gas tank was eliminated; as a result, the tank stern was also assembled from inclined sheets. The engine cooling system, unlike the BT-7, operated in two modes: combat and travel. In the combat position, the blinds were hermetically closed from the driver's seat and air was taken through the mesh of the aft air pockets. In the stowed position, the air intake was carried out through the side opening louvers. After blowing off the engine, the heated air came out through the aft louvers. The BT-SV turret did not have a niche, so the radio station was moved to the bow of the hull, where the fourth crew member, the radio operator, was located. The BT-SV hull was made of ordinary steel sheets 10–12 mm thick. The real armor project existed in two versions. The first provided for the use of FD grade armor 40–55 mm thick, which protected from 45 mm shells at all distances; the second was designed to protect against bullets of 12.7 mm caliber and assumed the use of 20–25 mm armor of the IZ brand.

[edit]
  • Библиотека военной истории. Энциклопедия танков, Санкт-Петербург, 1998 год. Составитель Холявский Г. Л., Издатель АТС, 578стр., ISBN 985-433-253-5
  • Резник Я. Л. (1987). Сотворение брони. Документальная повесть (65000 экз ed.). М.: Воениздат.