Jump to content

NZR R class

From Wikipedia, the free encyclopedia

NZR R class
NZR R class on Jervois Quay, Wellington, circa 1900, on the Te Aro Branch.[1]
Type and origin
Power typeSteam
BuilderAvonside Engine Co., England
Build date1878-79
Specifications
Configuration:
 • Whyte0-6-4T
Gauge3 ft 6 in (1,067 mm)
Driver dia.36.5 in (0.927 m)
Wheelbase21 ft 10 in (6.65 m)
Adhesive weight20 long tons (20.3 t; 22.4 short tons)
Loco weight33 long tons (33.5 tonnes; 37.0 short tons)
Firebox:
 • Grate area11.8 sq ft (1.10 m2)
Boiler pressure160 lbf/in2 (1,103 kPa)
Heating surface556 sq ft (51.7 m2)
CylindersTwo, outside
Cylinder size12.25 in × 16 in (311 mm × 406 mm)
Performance figures
Maximum speed53 mph (85 km/h)
Tractive effort8,420 lbf (37.45 kN)
Career
OperatorsNew Zealand Railways Department
Number in class18
Disposition1 preserved

The NZR R class was a class of early 0-6-4T single Fairlie steam locomotives operated by New Zealand's Railways Department (NZR) between 1879 and 1936.[2]

Introduction

[edit]

In the 1870s New Zealand's railway network was a small, fragmented system of light railway lines built in rough country where short, steep grades and tight curves were common. The Fairlie type of steam locomotive was well-suited to working in such conditions. In 1872, the first Fairlie locomotives arrived from England, the E class. Gradually the number of these double-ended engines (known as Double Fairlies) grew to 10, and came to include the B class of 1874. There was still a need for orthodox engines with Fairlie manoeuvrability. The Avonside Engine Company of Bristol, England solved the problem by providing both the R and S classes of Single Fairlie engines; 18 of the former in 1878-79 and 7 of the latter in 1880-81.[3] The R class locomotives were built at Avonside's Bristol factory and then shipped to New Zealand, with all entering service by early March 1880.[4]

The locomotives quickly earned a good reputation for speed and manoeuvrability. On a trial run, Charles Rous-Marten timed one as running from Upper Hutt to Wellington, a distance of 20 miles, in 32.5 minutes despite a number of short delays amounting to three minutes; one section of two miles was covered at a maximum speed of 53 miles per hour. They were allocated to depots across the country, and during their working life operated almost all types of services from premier passenger trains to shunting tasks. As built, they could carry 716 gallons of water, but to allow them to operate over extended distances, some were later fitted with 900 gallon side tanks. All were reboilered during their lives to raise the boiler pressure from 130 to 160 pounds per square inch.[3]

Accidents

[edit]
R 28 overhanging Lyttelton wharf on 23 March 1907.

The locomotives were involved in a number of accidents. On 23 March 1907, R 28 was running the Boat Train to the wharf at Lyttelton to connect with the Wellington ferry when it ran the stop-block. The driving frame, wheels and engine took a dive into Lyttelton harbour, but because of the design, the rest of the locomotive remained on the wharf.

Reefton Fairlie Engine

Retirement

[edit]

The R class were gradually withdrawn from NZR service between 1919 and 1944, when R 29 was retired.[5][6] Three R class locomotives went to the Manawatu County Council for use on the Sanson Tramway, two of which were given away free by NZR for use as spares. Another branch of government, the Public Works Department, acquired R 33 in August 1919. Five more were withdrawn in March 1922, and withdrawals continued throughout the 1920s, with only three surviving in NZR ownership into the 1930s. R 271 was retired in March 1936 and dumped at Oamaru at the foreshore. R 29 was on NZR's books until 1944, when sold to the Sanson Tramway. Her last years operating the NZR Stores Branch tram at Mamaku. Ironically due to its 1907 wharf accident, R 28 was sold to the Timaru Harbour Board in 1934. Until 1940, it was for shunting the Timaru wharves. It was later sold to Burkes Creek Colliery, Reefton for use on their mining railway. Laid up in 1948, R 28 was later placed in Reefton's town park for static preservation. In 2000 a working group took over care for the locomotive, where it will be moved into the restored Reefton engine shed for ultimate restoration to working order.[4]

See also

[edit]

References

[edit]

Citations

[edit]
  1. ^ "R Class steam locomotive on Jervois Quay, Wellington, [1900s]. Reference Number: 1/2-106887-F". National Library of New Zealand. Retrieved 17 March 2019.
  2. ^ Palmer & Stewart 1965, p. 47.
  3. ^ a b T. A. McGavin, Steam Locomotives of New Zealand, Part One: 1863 to 1900 (Wellington: New Zealand Railway and Locomotive Society, 1987), 34-5.
  4. ^ a b New Zealand Railways Steam Locomotives, "R Class 0-6-4T Register", accessed 9 December 2007.
  5. ^ Register of New Zealand Railways Steam Locomotives Pg150
  6. ^ Mahoney 1998, p. 179.

Bibliography

[edit]
[edit]